Further ESC testing. Running solid AF.
Related Posts
VALKYRIE UNMANNED DRONE – FULL ANALYSIS
Link to Flight Video: https://youtu.be/QrJmG1g4mFI Air superiority plays a very important aspect in modern …
Holy Stone HS200W With FPV and Altitude Hold
I thought I would share this here. I have been doing a lot of …
The Most Beautiful Drone Footage from our Trans USA Bike Ride-DJI Mavic Air
This is a compilation of the most beautiful drone shots from our cross country …
Yizhan Tarantula X6 Quadcopter – 23042016
Camera: Midland XTC-280 I observed a signal drop at 330 meters of altitude and …
Skywalker Smart Dual Rotor FPV Wing Maiden Test Flight
You can order the plane here http://bit.ly/2BLXusn Skywalker Smart Dual rotor FPV wing is …
DRS Stettfeld fpv race final run serg fpv
Here’s the DVR of my final run at the last Drone Racing Series Qualifier …
Damn! That is nuts! I will be getting some of those ESC!
Dang! Any fpv footage for comparison?
Where was this flown?
Sick, how many watts are those motors? Pretty sure that was not what KDE expected they were going to be used for ?. Impressive power from those esc’s! Love the frame too ?
Did you have your throttle limit set at anything below 100%?
BTW I discovered some problem with CF props, actually contributing to comms losses. Apparently spinning conductive materials around at 20000rpm doesn’t do good things to RF. If you find problems with comms, you’ll know its this. Took me 6 months of wondering WTF.
Man I hope you have a pre-arm switch! I can’t count how many times I’ve bumped that protruding switch on top of my QX7 and prematurely armed one of my quads when walking over to set it on the ground for a launch.