As you can see, It was open area without trees but drone fell for unknown reasons. I suspect that there are defects/issues in my model.
max distance – 50m not (300-500m)
Related Posts
Setting your Trims for BetaFlight and Arming from Cyclone FPV
I strive to provide videos that will be informative and helpful to all of …
HolyStone HS160 bonus footage
Hey guys sorry this is a little late, I have the footage from the …
iNav V1.9 Wing Build: Basic setup and installation (Orbit Wing and F35 FC)
See all about iNav 1.9 here – https://github.com/iNavFlight/inav/releases Download iNav from here – https://github.com/iNavFlight/inav-configurator/releases …
![[SOLVED] Quad problem motor spinning after armed and then stopped](https://quadcoptersource.tesb1.com/wp-content/uploads/2018/03/SOLVED-Quad-problem-motor-spinning-after-armed-and-then-stopped-200x137.jpg "[SOLVED] Quad problem motor spinning after armed and then stopped")
[SOLVED] Quad problem motor spinning after armed and then stopped
Quad problem motor spinning after armed and then stopped. I have checked the configuration, …
Epic Drone Fail Crash – HD QUALITY – 2015 Compilation
Some epics drone & quadcopter fail & crash. Drones versus Animals, Drones vs Trees… …
DRONE CRASH. Lost $ 550 / Fails Drone, Quadcopter, Сopter
Drone Crash. Сopter crash. Quadcopter crash. Lost $ 550. Fails Drone. Quadcopter Fails. Сopter …
look arund…there MUST be something interfering with the signal..
i have had mine out to 315m with no problems..
make sure your not holding the controller facing down..
the place where you think the antenna points up..is not where it actually is inside.
the wire for it is in the middle of it..so make sure the back of your controller is pointing toward the quad…and test it again.