EMAX NightHawk PRO 280 FPV Race Drone Review – Part 1 [UnBox, Inspection, Setup]
Here’s part one of my full review of the EMAX NightHawk 280 Pro Race Drone http://goo.gl/Ivmp6k
Here I go through what you get in the box, inspection and setup. This one seems like a good choice for someone to get right into the race scene with minimal setup…just add batteries!
Check out Part 2 of the review which will be up soon for the Flight Test and pros & cons.
.nice videos keep up the good work
….basically this is a good review too. Basically 🙂
I was even think about to count how many time you say ‘basically at one of
your vid, but I too lazy to do that 🙂
Sorry for the comment, just a viewer here. keep up the good work.
Good job Dustin. Pretty impressed with the craft, and glad they used a Naze
controller. I am using one of my Taranis switches to arm/disarm my motors,
and they DO NOT spin up when armed! I suppose the RX is some sort of DSM
DSMX type, which means if you use your Taranis, you’ll need to use the
module. (Probably running PWM mode too … PPM is a bit cleaner imho) Nice
clean layout .. cleaner than my 1st (and only) build, but things have
progressed a lot, with integrated PDBs and ESCs and stuff. Will look
forward to Part 2. Mahalo!
Racing club?! Aww, man, you’re so lucky. Where I live, nobody even knows
what q quadcopter is…
Thanks for this excellent review. I have a question on the buzzer…how
does it work concretely when there is no telemetry broadcasted to the
goggles or transmitter? Is it loud enough to warn you that the voltage is
low?
Very good interview, looking forward to part 2! Are these quanum or diy
goggles?
don’t the red props go in the front?