Drone DJI F550 frame with E305 system, Naza V2 flight control and motor failure test.
FrSky Taranis X8R radio control system.
Frame: DJI F550 flame wheel
Flight Controller: DJI NAZA-V2 GPS
Power Distribution: Integrated on lower center plate
Batteries: 4s 6000mah
ESC: DJI OPTO 20a lite
Motors: DJI 2312e 950kv
Props: DJI 9 x 4.5 zblade cc & ccw
Tx: FrSky Taranis with voltage telemetry
Rx: FrSky X8R
Camera: Mobius action cam
Video Tx: 5.8 Ghz Immersion Rc 600 mW
Video Rx: 5.8 Ghz Immersion Rc
AUW: 2137g w 4s 6000mah and Zenmuse H3-3d gimbal, Gopro camera
Flight Time: 10 minutes
![FPV CINEMATIC : ARDECHE | Drone [4K]](https://quadcoptersource.tesb1.com/wp-content/uploads/2021/02/FPV-CINEMATIC-ARDECHE-Drone-4K-200x137.jpg "FPV CINEMATIC : ARDECHE | Drone [4K]")
not bad from naza ma v2, however the system runs the most efficient on
spirodash f560 frames. its superlight almost haf the weight as the f550
frame
I hope you’re able to confirm this: I just installed a E305 system and
noticed that when I push the throttle down, the motors keep spinning for a
few seconds before completelly stop (after being spinning). Does this
happen to you? I’m using Pixhawk/APM, but I didn’t get such behaviour with
E300.