I am flying my Chameleon Ti with Emax LS2207 motors blasting 6S 95C Tattu 1300mAh batteries. I’m running Betaflight 4.0.0#1101 with the new dynamic filter which performs great! This build is pure power and torque. FPV is so much fun!
These are the parts I used in this Chameleon TI build:
OmniNXT F7 Flight Controller 32kh [https://amir.ch/lnkKJRU]
Typhoon32 V2.2 4in1 BLHeli_32 35A 2-6S ESC [https://amir.ch/lnkKJRT]
4x EMAX LS2207 Lite Spec 2207 2400KV Brushless Motor [https://amir.ch/lnkABEF]
Armattan Chameleon TI 5″ Frame [https://amir.ch/lnkTGHI]
4x Realacc M3*7+4.5 Flight Controller Anti-Vibration Fixed Screws [https://amir.ch/lnkGEDA]
2 Pairs HQProp DP 5.1×4.6×3 Durable PC Propeller (light red) [https://amir.ch/lnkKJRV]
RunCam Micro Eagle 1/1.8″ CMOS 800TVL WDR 16:9/4:3 Switchable FPV Camera [https://amir.ch/lnkHIBB]
2 Micro Camera Mount Bracket for RunCam Micro Eagle [https://amir.ch/lnkHIJM]
AKK X2-ultimate VTx [https://amir.ch/lnkUKAB]
UFOFPV 5.8G LHCP RX/TX FPV Pagoda Antenna [https://amir.ch/lnkARFG]
FrSky R-XSR SBUS 16CH Mini Redundancy Receiver (1.5g) [https://amir.ch/lnkGFRT]
GOPRO Hero 5 Session [https://amir.ch/lnkUKAC]
Panasonic TP RADIAL Alu Kondensator 2000μF Low-ESR [https://amir.ch/lnkHGBF]
These are some accessories I use for it:
4x FPVRacing 1350mAh 5S 95C LiPo Battery (XT60) [https://amir.ch/lnkUJHN]
Eachine VR D2 Pro 800*480 40CH 5.8G Diversity FPV Goggles [https://amir.ch/lnkHIJK]
iSDT SC-620 500W 20A MINI Smart LCD Battery Balance Charger [https://amir.ch/lnkTGHU]
The drone essentially consists of a commercial frame from Armattan combined with some original parts from Runcam and Frsky. The lifetime frame guarantee of Armattan gives a lot of peace of mind when flying.
The links in the list above for the flight control and BLC point to a german shop. I would propose to buy the flight controller and BLC from a respectable shop in Europe to make sure they are built with a certain amount of quality control. Also please be aware that the above links to Banggood are affiliate links.
what props are you running on this setup. look smooth!?
Are you using any type of throttle curve? I’m building a 6s rig and the motors I want don’t have low KV available to me at the time. I want to rip like you haha
did you make any changes to the filters? im also runing 4.0 with an f7 fc