How to Calibrate an ESC using Flysky Radio Controller | Esc calibration03:25

#tech_SL
#Esc_Calibration

ESC Calibration

1.Plug one of your ESC three-wire cables into the throttle channel
of the RC receiver. (This is usually channel 3.)

2.Turn on the transmitter and set throttle stick to maximum (full
up).

3.Connect the LiPo battery

4.You will hear a musical tone then two beeps.

5.After the two beeps, lower the throttle stick to full down.

6.You will then hear a number of beeps (one for each battery cell
you’re using) and finally a single long beep indicating the end points have been set and the ESC is calibrated.

7.Disconnect battery.

8.Done calibaration

MUSIC :
Konrad Mil – Infinity 2018
https://www.youtube.com/watch?v=hhUHTJKfBF4

———-
Edited in :
Adobe Premiere Pro CC
Adobe Photoshop CC
———-

Thanks for watching!!!!

———-
THANK YOU