Audio Track: Axol x Alex Skrindo – You by NCS
Testing the current draw on my DIY quadcopter, specs in the video.
Related Posts
JJRC H16-5D 2.4GHz, 4Ch, 6 Axis Gyro, RC Quadcopter with Headless mode and 5MP Camera (RTF)
JJRC H16-5D Review: https://goo.gl/3bXBFq JJRC H16-5D (Yi ZHAN Tarantula X6) 2.4GHz, 4Ch, 6 Axis …
Mini brushless drone build – ESCs (beginners guide) part1
Coretexrc tiny90 components used: motors, escs, flight controller.
FPV Drone Freestyle (Sunset through the Trees) with Hyperlow CG
Frame: Hyperlow CG 5″ Motors: Hypetrain 2306 2450kv Props: HQ 5×4.5×3 FC: Holybro Kakute …
Arduino based quadcopter flips during takeoff
During the first trial of flight controller the quadcopter flips.. the flight controller is …
Reframe HGLRC XJB into a Ummagawd AcroBrat 3 inch build
Reframe HGLRC XJB into a Ummagawd AcroBrat Consider supporting the channel: https://www.patreon.com/tronage Links Specific …
Luide Mulumba – Is that a DJI spec sheet?
if so, could be because DJI used their equipment.
What APM is that?
Liked and subbed
Luide, thank for your video. My drone only have a one XT90 conector from the battery to the drone, I will conect the Jumper Wire and the negative polo from the Multimeter in the same XT90 to my drone. Can I made this? Can I have a problem?.
Was the meter measuring RMS current?
How does this draw below 10 amps? I think it should be 100 amps for a drone this size!
Luide, thank for your video. My drone only have a one XT90 conector from the battery to the drone, I will conect the Jumper Wire and the negative polo from the Multimeter in the same XT90 to my drone. Can I made this? Can I have a problem?.