In this video I test the Motors, ESC and Propellers for my quadcopter project.
I wanted to build a Quadcopter for a long time now and today I did some testing with the parts that came in. It is my first time working with LiPo batteries, ESC’s and Brushless motors and I got to say that I’m impressed by the power this stuff produces.
Because I don’t have a flight controller yet I used a Arduino Nano for this test. A potentiometer is used to regulate the throttle of the setup.
Support the channel: http://paypal.me/mbcreates
These are discount links for the parts
1.4 PCS DYS Samguk Series Shu 2306 2500KV 3-4S Brushless Motor for RC Drone FPV Racing(39.90$)
https://bit.ly/2ISHHrU
2. 2.Racerstar RS30A 30A Blheli_S OPTO 2-4S ESC Support 16.5 Dshot150 Dshot300 for FPV Racing(10.99$)
https://bit.ly/2JdbBdQ
3. 3.2 Pairs Dalprop Cyclone T5050C CW CCW 3-blade Propeller 5mm Mounting Hole for RC Drone FPV Racing(28%OFF 2.99$)
https://bit.ly/2JbXdCk
…………………………………………………..
Music
Me 2 (Feat. Julian Avila) by LAKEY INSPIRED https://soundcloud.com/lakeyinspired
Creative Commons — Attribution-ShareAlike 3.0 Unported — CC BY-SA 3.0
http://creativecommons.org/licenses/b…
Music promoted by Audio Library https://youtu.be/C8EM6IrN8tA
Oh weee, big test hey… Go away…. hehe
Informative Vids, nice, thx
This info reads in the datasheet. A few back-of-the-envelope calculations would have revealed how much it can lift.
Could you Please help me
keep clam and go ahead
Sounds like at least one of those has a dodgy bearing. :/ With those low end motors it’s good to keep a spare or two on hand.
You’re probably still better off buying 2 sets of cheap ones than 1 set of good ones while you’re learning, since you’ll undoubtedly break a lot of stuff early on.
12 volt ki battery se chalegi kya
Hey, Can you tell me where did you buy that black holder and what is it called?
can you share the sketch plz?
thx for the video.